E100 and Micromite Backpack port tester PCB
This PCB can be used to test that all the pins are intact and working correctly via LED's. Designed to plug directly into the LCD port of an E100 board, or by flipping the board 180 degrees, you can also use it to check the connections on an SPI-LCD-based Micromite Backpack unit. The backpack port tester can also be used to test ANY supported SPI LCD module with touch, but you will need to change the tester code to reflect you chosen pins. This is just the PCB - you will need to supply the components: 4x 3k3 standard resistors, 29x super-bright LED's, 1x 40-pin(2x20) box-header(standard 2.54mm pitch), 1x pin-strip(14w). Use 1k resistors instead of 3k3 if you are using standard LED's. MMBASIC code to run this tester on an E100 or Micromte Backpack can be downloaded from our Downloads page.US$5.00 + US$15 tracked shipping.